Names Of Operation Section - Takex PXB-100ATC Instruction Manual

1-3

NAMES OF OPERATION SECTION

Cover Detect Switch
Cover Detect Switch
[Transmitter]
Transmission LED
(Upper/lower)
Upper/lower changeover switch
"9 EXPLANATION OF FUNCTIONS
(9-2 UPPER/LOWER CHANGEOVER FUNCTION)"
6,7,8. Vacant
5. Beam power switch (Factory set : H)
"5 INITIAL SETTING (5-4 BEAM POWER SELECTION )"
Master/Slave selection switch (Factory set : Master)
4.
"5 INITIAL SETTING (5-3 MASTER/SLAVE SELECTION)"
3. Synchronized timing switch (Factory set : A)
"5 INITIAL SETTING (5-2 SYNCHRONIZED TIMING)"
1,2. Transmitter channel changeover swicth (Factory set : 1CH)
"5 INITIAL SETTING (5-1 MODULATION FREQUENCY CHANGEOVER)"
[Receiver]
Alarm LED : Red
Sensitivity attenuation LED : Red
Light reception authorization LED
(Upper/lower)
Upper/Lower changeover switch
"9 EXPLANATION OF FUNCTIONS
(9-2 UPPER/LOWER CHANGEOVER FUNCTION)"
Monitor Jack
Auto-gain lock switch
(Factory set : OFF)
Please set "ON" after complete optical axis adjustment.
"9 EXPLANATION OF FUNCTIONS (9-1 AUTO GAIN LOCK FUNCTION)"
8. Sound check switch (Factory set : OFF)
"5 INITIAL SETTING (5-8 SOUND CHECK)"
6,7. Detection response time adjustment switch (Factory set : 0.1sec)
"5 INITIAL SETTING (5-7 RESPONSE TIME)"
5. Environmental output switch (Factory set : N.C.)
"5 INITIAL SETTING (5-6 ENVIRONMENTAL OUTPUT SWITCH)"
4. Alarm output switch (Factory set : N.C.)
"5 INITIAL SETTING (5-5 ALARM OUTPUT SWITCH)"
3. Synchronized timing switch (Factory set : A)
"5 INITIAL SETTING (5-2 SYNCHRONIZED TIMING)"
1,2. Receiver channel changeover switch (Factory set : 1CH)
"5 INITIAL SETTING (5-1 MODULATION FREQUENCY CHANGEOVER)"
3
: Red