Table of Contents
Advertisement
4.1.3
Speed calculation
Speed is normally entered automatically, from your navigator. If the navigator fails,
manually enter speed.
1. Open the [Parameter Setup] menu.
2. Rotate the Course control knob to select the current setting for [Speed Calcula-
tion] then push the knob.
3. Rotate the Course control knob to select [Auto] or [Manual] then push the knob.
4. For [Auto] go to step 5. For [Manual], do as follows:
1) Rotate the Course control knob to select the current value then push the
knob.
2) Rotate the Course control knob to set a value then push the knob (setting
range: 0.1 - 99.0).
5. Press the
4.2
Rudder Drive Level (For Fantum Feedback
For Fantum Feedback
can be adjusted. The higher the setting, the less helm required to move the rudder.
1. Long press the
2. Rotate the Course control knob to select the current value for [Rudder Drive Lev-
el] then push the knob.
Note: When the rudder reference unit is installed, [Rudder Drive Level] does not
appear.
3. Rotate the Course control knob to set a value then push the knob (setting range:
1 - 20).
4. Press the
key three times to close the menu.
™
, the amount of helm operation required to move the rudder
key to open the menu.
key to close the menu.
4. USER MENU
™
)
4-5
Advertisement
Table of Contents
