Table of Contents
Advertisement
7. Rotate the Course control knob to set the return delay then push the knob.
The setting range is 1-20 seconds.
• NAV mode: When the data from the helm sensor is not input for the set time,
the NAV mode is restored.
• AUTO, WIND mode, etc. (except NAV mode): When cruising straight ahead
and the data from the helm sensor is not input for the set time, the previous
steering mode is restored.
8. Rotate the Course control knob to select [Safe Helm Response] then push the
knob.
Safe Helm Response
Response:
6
Turn helm to PORT/STBD to set
Safe Helm response time.
Higher value = Faster
response.
Push MENU key to return
9. The cursor is selecting the current value for [Response]; push the Course control
knob.
10. Rotate the Course control knob to select a value then push the knob.
The higher the setting, the faster the response (setting range: 1-10).
11. Press the
key to close the [Safe Helm Response] window.
12. Rotate the Course control knob to select the current setting for [Safe Helm Beep]
then push the knob.
13. Rotate the Course control knob to select [ON] or [OFF] then push the knob.
[Safe Helm Beep] turns the beep on or off when the safe helm mode is activated.
14. Press the
key three times to close the menu.
When you turn the helm,
PORT STBD
PORT or STBD is highlighted
according to the rudder
direction.
Not shown with Fantum Feedback
2. STEERING MODES
TM
.
2-39
Advertisement
Table of Contents
