Can Bus Port Setup - Furuno NAVpilot 711C Operator's Manual

7.5

CAN bus Port Setup

The [CAN Bus Setup] menu sets up the equipment connected to the CAN bus port. To
open the [CAN Bus Setup] menu, select [CAN Bus Setup] from the [Installation Menu]
window.
1. The cursor is selecting [Device List];
push the Course control knob.
The [Device List] display shows the
name of the CAN bus equipment con-
nected to the CAN bus port. In the example illustration, the FURUNO heading
sensor PG-700 is connected. The series of alphanumerics which follow the model
name are the CAN bus unique number.
2. To change the device name, do the following. If you do not need to change the
name, go to step 3.
1) Push the Course control knob.
2) Rotate the Course control knob to select character then push the knob.
3) The cursor moves to the next character. Repeat step 2 to change the charac-
ter. You can select the input location with the
can have a maximum of 14 characters.
3. Press the
4. Rotate the Course control knob to select [Incoming CAN Bus data].
This display shows all the NMEA 2000 sentences that the NAVpilot is capable of
receiving. The Parameter Group Number (PGN) the NAVpilot is currently receiv-
ing are highlighted.
CAN Bus Setup
Device List
Incoming CAN Bus data
Select Output PGN List
Refresh: No
key to return to the [CAN Bus Setup] menu.
Incoming CAN Bus data
059904 060928 126208
126996 127250 127251
127489 128259 128267
129029 129033 129283
130306 130310 130311
130314 130577
Device List
PG-700: 0019E4
and
126464
126992
127258 127488
129025 129026
129284 129285
130312
130313
7. INITIAL SETTINGS
keys. The name
7-23