Initial Settings - Furuno NAVpilot-700 Installation Instructions Manual

4. Initial Settings

This section shows you how to select language and units and open the [INSTALLATION] menu.
For details of the settings on the [INSTALLATION] menu, see the document below.
• NAVpilot-700/711: Installation manual (IME-72720)
• NAVpilot-711C: Operator's manual (OME-72780)
The display examples in this section are shown for NAVpilot-700/711.
1. Press the POWER/BRILL key or POWER/STBY key to turn on the power.
The first time the system is powered, the language selection menu appears.
2. Rotate the knob to select required language, and then push the knob.
3. Press the key to show the [UNIT SETUP] menu.
1) Select the item to change then push the knob.
2) Select the unit to use then push the knob.
4. Press the key to show the [OPERATION MODE] menu.
UNITS SETUP
SPEED UNIT:
RANGE UNIT:
WIND SPEED UNIT:
DEPTH UNIT:
WATER TEMP UNIT:
PREV NEXT
OPERATION MODE
INSTALLATION
DEMO SLIDE SHOW
SIMULATOR
PREV NEXT ENTER
8
kn
nm
kn
ft
°F