Table of Contents
Advertisement
Encore Profile Pro WW
DMX Addressing
DMX ADDRESSING
All fixtures should be given a DMX starting address when using a DMX controller, so the correct fixture
responds to the correct control signal. This digital starting address is the channel number from which
the fixture starts to "listen" to the digital control signal sent out from the DMX achieved by setting the
correct DMX address on the digital control display on the fixture.
You can set the same starting address for all fixtures or a group of fixtures, or set different addresses
for each individual fixture. Setting all fixtures to the same DMX address will cause all fixtures to react
in the same way, in other words, changing the settings of one channel will affect all the fixtures
simultaneously.
If you set each fixture to a different DMX address, each unit will start to "listen" to the channel number you
have set, based on the quantity of DMX channels of each fixture. That means changing the settings of one
channel will only affect the selected fixture.
1 8
Advertisement
Table of Contents
