Table of Contents
Advertisement
advanced setup
TIME UNIT SETUP
You can use this menu to specify the time unit.
1.
Press the
F 2
SETUP MENU button.
4
2.
Use the buttons
.
ENT
4
3.
Use the buttons
•
UNIT: 1SEC : The output time is calculated by the second in the I/O
setup.
UNIT: 0.1SEC : The output time is calculated by the 1/10 second
M
The default is set to "UNIT: 1SEC".
see the following example
If you want to keep the Door Relay (Relay #1, DR) active for 3 seconds, follow the steps below:
- Set the time unit to 1 second.
- Set the Door Relay (DR) output time to "03".
If you want to keep the Door Relay (Relay # 1, DR) active for o.5 second, follow the steps below:
- Set the time unit to 0.1 second.
- Set the Door Relay (DR) output time to "05".
Your change to the time unit will affect all I/O time settings.
OUTPUT TIME SCHEDULE+ID
The Output T/S+ID feature is used, in particular, in opening the door for a specifi ed time period in a specifi c time schedule.
However, you can set it not to open the door after the specifi ed time unless a user entry (i.e., entering the ID) is attempted.
The closing time is, of course, the end point of the specifi ed time period.
F 2
1.
Press the
SETUP MENU button.
4
2.
Use the buttons
press
.
ENT
4
3.
Use the buttons
•
NOT USE : The entrance door is set to be open when it reaches the
specifi ed time in the time schedule code.
USE : The entrance door will be not open when it reaches the specified
time in the time schedule code, but is open when a registered
user is authenticated.
M
Time schedule must be confi gured before. (See Page 55 for "Time Schedule Setup".)
The Output T/S + ID is set to "NOT USE" by default.
6
and
to move to the TIME UNIT item and press
6
and
to specify the time unit and press
(100ms) in the I/O setup.
6
and
to move to the OUTPUT T/S + ID item and
6
and
to select USE or NOT USE, and press
3.TIME UNIT
UNIT: 1SEC
.
ENT
3.TIME UNIT
UNIT: 0.1SEC
4.OUTPUT T/S + ID
NOT USE
.
ENT
4.OUTPUT T/S + ID
USE
English47
Advertisement
Table of Contents
