Table of Contents
Advertisement
TO REMOVE THE MASTER IDs
If you want to remove all master IDs (card IDs), use this menu.
1.
Press the
F 8
SETUP MENU button.
4
2.
Use the buttons
press
.
ENT
1
3.
Press the button
•
To cancel the work, press the button
J
Before removing all master IDs, ensure that the master IDs are no longer in use.
DURESS MODE
You can set Duress Mode for READER#1. Duress mode is a special feature that outputs a special alarm signal when a
it is forced to open the restricted area, whose default is NOT USE. When selecting USE, you are prompted to enter the
two-digit numbers for the Duress mode password, whose default is '00'.
If it is set to USE, enter the two-digit Duress password and press
alarm signal is transmitted to the host PC.
1.
Press the
F 2
SETUP MENU button.
4
2.
Use the buttons
press
.
ENT
4
3.
Use the buttons
•
NOT USE : Duress Mode is disabled.
USE : If set to USE, proceed with the followings:
4.
The DURESS password is shown.
Press
.
ENT
5.
Enter the two-digit password and press
M
The Duress Mode password should be different from the Arm/Disarm code.
You can specify the output time for each signal out for Duress Alarm. (See Page
43 for "Duress Mode Output Setup".)
6
and
to move to the MASTER ID CLR item and
to delete all registered master IDs.
0
.
6
and
to move to the DURESS MODE item and
6
and
to select USE.
.
ENT
4. MASTER ID CLR
4.MASTER ID CLR
1:YES, 0:NO
; this will open the door normally, but the Duress
ENT
6.DURESS MODE
NOT USE
6.DURESS MODE
USE
DURESS PASSWORD
ENTER DURESS P/W
00
█
English33
Advertisement
Table of Contents
