Table of Contents
Advertisement
User Manual of Thermal Bi-spectrum Network Speed dome
2. Set the vandal-resistance alarm.
(1) Slide the bar to adjust the sensitivity of vandal-resistance detection.
(2) Check the checkbox of Upload Vandal-Resistance Alarm to upload the
vandal-resistance alarm.
(3) Check the checkbox of Enable Vandal-Resistance Alarm Voice Warning to enable the
voice warning of vandal-resistance alarm.
3. Set GPS settings.
(4) Select Longitude-Latitude Mode as Manual.
(5) Select longitude and latitude as East or West according to the actual position.
(6) Enter the value of longitude and latitude in three textboxes.
4. Click
7.3.9 Configuring Linear Scan
Steps:
1. Get to the linear scan interface:
Configuration > Advanced Configuration> PTZ > Linear Scan.
2. Select Camera 1 or Camera 2 from the Channel No. list.
3. Zoom in and zoom out the camera to the appropriate zoom ratio.
4. Click Save Ratio to save the zoom ratio.
5. Optionally, you can click Enable Saved Ratio to set the camera to the saved zoom ratio.
6. Click Set Scan Area and set the left/right/up/down limits with the PTZ control panel and
© Hikvision
to save the settings.
Figure 7-36 Linear Scan
107
Advertisement
Table of Contents
