[Pc Settings For Redscan Manager] - Optex REDSCAN Series Manual

[PC Settings for REDSCAN Manager]

REDSCAN mini has 2 LAN ports, main and maintenance.
Default settings of main Ethernet Port:
⚫
IP Address
Subnet Mask
Default Gateway
⚫ Default settings of Maintenance Port:
IP Address
Subnet Mask
Change network settings of the PC to communicate with REDSCAN. (Example: 192.168.0.100 and
1.
255.255.255.0 for communication with main port)
⚫ Windows 7
(1) On the taskbar, click Start, click Run command, enter ncpa.cpl and press Enter key.
(2) Select Local Area Connection to which the REDSCAN unit is connected and then display Properties.
(3) Select Internet Protocol (TCP/IP) under General, and set the IP address and subnet mask from
Properties.
⚫ Windows 8.1
(1) On the taskbar, click Start, click Search, enter ncpa.cpl and press Enter key.
(2) Select Local Area Connection to which the REDSCAN unit is connected and then display Properties.
(3) Select Internet Protocol Version 4 (TCP/IPv4) under General, and set the IP address and subnet mask
from Properties.
⚫ Windows 10
(1) Enter ncpa.cpl in Search on the taskbar, press Enter key.
(2) Select Local Area Connection to which the REDSCAN unit is connected and then display Properties.
(3) Select Internet Protocol Version 4 (TCP/IPv4) under General, and set the IP address and subnet mask
from Properties.
Change firewall settings of the PC.
2.
⚫ Windows 7
(1) On the taskbar, click Start, click Run command, enter Firewall.cpl and press Enter key.
(2) On the left of the screen click Advanced settings.
192.168.0.126
255.255.255.0
192.168.0.1
192.168.1.126
255.255.255.0
25