Optex REDSCAN Series Manual page 53

[Detection Mode] (Default: Outdoor mode)
⚫ Outdoor mode
This option is for general outdoor applications. As required, select the Vertical or Horizontal setting,
and then set any additional settings.
⚫ Outdoor Fence/Wall top protection mode
Select this mode if you want to detect a person trying to climb over a fence with the REDSCAN unit
installed in a general outdoor environment. This mode is available only if it is installed horizontally.
⚫ Outdoor Loitering detection mode (version 8.0.0 or later)
Select this mode if you want to detect loitering object within the detection zone in general outdoor
environment.
⚫ Indoor Mode
For general indoor applications, e.g. warehouse, this option can be selected. In this mode,
Environmental Resistance and DQ Output are disabled.
⚫ Indoor Fence/Wall top protection mode
Select this mode if you want to detect a person trying to climb over a fence in indoor environment.
⚫ Indoor Loitering detection mode (version 8.0.0 or later)
Select this mode if you want to detect loitering object in indoor environment.
[Detection Area] (Default: H2)
There are 2 options, Horizontal Detection Area 2 and Vertical Detection Area.
⚫ H2 (Horizontal Detection Area 2)
This mode allows setting of a fan-like detection area in the horizontal direction with a maximum radius
of 30 m (Approx. 100 ft.), a spread angle of 190 degrees.
This mode detects intrusion into the detection area from any direction.
The Redscan will generate the alarm output 1 minute (variable) after the initial detection, so long as
the detected object stays in the detection area.
53