Table of Contents
Advertisement
Chapter 5
Considerations When Using 5B or 7B Series Signal
Conditioning Modules
46
• When first installing the board, it is recommended that you do
the following:
− Wire a function generator or a known voltage source to analog
input channel 0 (use the differential configuration).
− Wire an oscilloscope or voltage meter to analog output
channel 0.
− Wire a digital input to digital I/O Port A.
− Wire a external clock or scope to counter/timer channel 0.
− If you have not done so already, install the DT3010 Series
software.
− Run the Quick Data Acq application (described in
starting on page
properly.
− Once you have determined that the board is operating
properly, wire the signals according to your application's
requirements.
When using a DT3010-268 with an STP268-EC screw terminal panel
and a 5B or 7B Series signal conditioning backplane and modules,
keep the following considerations in mind:
• The 7BP04-1 backplane maps to single-ended analog input
channels 0 to 3.
• The 5B08 and 7BP08-1 backplanes map to single-ended analog
input channels 0 to 7.
105) to verify that the board is operating
Chapter 6
Advertisement
Table of Contents
