Table of Contents
Advertisement
Chapter 3
Figure 4: Inserting the DT3010-268 Board in the Computer
20
EP324 Cable and
Face Plate
Rear of Computer
PCI Expansion Slot Bus Connector
2.
Carefully lower the board into the PCI expansion slot using the
card guide to properly align the board in the slot.
3.
When the bottom of the board contacts the bus connector, gently
press down on the board until it clicks into place.
Do not force the board into place. Moving the board from side to side
during installation may damage the bus connector. If you encounter
resistance when inserting the board, remove the board and try again.
Secure the board in place at the rear panel of the system unit
4.
using the screw removed from the slot cover.
DT3010-268
Board
CAUTION:
Advertisement
Table of Contents
