Table of Contents
Advertisement
Chapter 3
Attaching the EP324 Cable (DT3010-268
Board Only)
EP324 ribbon cable
with face plate
Figure 2: Attaching the EP324 Cable to the DT3010-268 Board
18
If you are using a DT3010-268 board and want to access the dynamic
digital outputs, digital I/O port B, or counter/timers 2 and 3 of the
board, you need to use the STP268 screw terminal panel and the
EP324 cable that is shipped with the board.
Attach the end of the EP324 that does not have the face plate to
connector J2 on the DT3010-268 board, as shown in
Refer to
page 30
for information on attaching the STP268 screw
terminal panel.
Connector J2
Figure
2.
Advertisement
Table of Contents
