Table of Contents
Advertisement
Chapter 4
42
To use channel 15 on the 5B01 or 7BP16 backplane as analog output
channel 1, install jumpers W3 (DAC1) and W4 (DAC1 Ground) on the
STP268-EC screw terminal panel.
Refer to
Figure 14 on page 39
W4.
For example, assume that you are using a 5B01 with the DT3010-268
and that you want to use analog output channels 0 and 1. In this case,
ensure that you wire DAC0 signals to channel 14 and DAC1 signals
to channel 15 on the 5B01 backplane. Then, install jumpers W1
through W4 on the STP268-EC screw terminal panel.
for the location of jumpers W1 through
Advertisement
Table of Contents
