Attaching A 5B Or 7B Series Backplane - Data Translation DT3010 Series Getting Started Manual

Chapter 4
DT3010-268 Board
Figure 8: Attaching an STP268-EC Screw Terminal Panel to the

Attaching a 5B or 7B Series Backplane

DT3010
Board
34
Connector J1
DT3010-268 Board
To connect a 5B01, 5B08, 7BP16-1, 7BP08-1, or 7BP04-1 signal
conditioning backplane to the STP268-EC screw terminal panel,
perform the following steps:
1. Plug one end of an AC1315 cable into the J3 or J4 connector of the
STP268-EC screw terminal panel, as shown in
J1 Connector
EP325
Cable
Figure 9: Connecting the AC1315 Cable to the
STP268-EC Screw Terminal Panel
2. If you are using a 5B Series backplane, plug the other end of the
AC1315 cable into the 26-pin connector on the 5B Series
backplane, as shown in
EP325 Cable
J1
STP268-EC
Screw Terminal
J3 or J4 Connector
STP268-EC
AC1315
Cable
Figure 10.
Figure 9.