Attaching A Screw Terminal Panel; Attaching The Dt740 Screw Terminal Panel - Data Translation DT3010 Series Getting Started Manual

Attaching a Screw Terminal Panel

If you are using the DT3010, DT3010/32, DT3010/32-268, or DT3016
board, you first need to attach the DT740 screw terminal panel to the
board before you can wire signals.
If you are using the DT3010-268 board, you first need to attach the
STP268 or STP268-EC screw terminal panel to the board before you
can wire signals.
This section describes how to attach the DT740, STP268, or
STP268-EC screw terminal panels to the appropriate DT3010 Series
board.

Attaching the DT740 Screw Terminal Panel

The DT740 screw terminal panel is provided for DT3010, DT3010/32,
DT3010/32-268, and DT3016 boards.
Connector J1 on the screw terminal panel brings out all of the analog
signals from connector J1 on the board; cable EP307 connects
connector J1 on the screw terminal panel to the DT3010, DT3010/32,
DT3010/32-268, or DT3016 board. Connector J2 on the screw terminal
panel brings out all of the digital and counter/timer signals from
connector J2 on the board; cable EP308 connects connector J2 on the
screw terminal panel to the DT3010, DT3010/32, DT3010/32-268, or
DT3016 board.
Figure 5 illustrates how to attach the DT740 screw terminal panel to
the DT3010, DT3010/32, DT3010/32-268, or DT3016 board.
Attaching and Configuring a Screw Terminal Panel
4
4
4
4
4
4
4
4
4
29