Attaching A Pb16H Opto-22 Backplane - Data Translation DT3010 Series Getting Started Manual

Chapter 4

Attaching a PB16H Opto-22 Backplane

DT3010
Board
EP325
Cable
Figure 12: Connecting the PB16H Opto-22 Backplane to the
36
To connect a PB16H Opto-22 backplane to an STP268-EC screw
terminal panel, perform the following steps:
1. Plug one end of an EP035 cable into the J2 connector of the
STP268-EC screw terminal panel.
2. Plug the other end of the EP035 cable into the 50-pin connector on
the PB16H Opto-22 backplane, as shown in
J1 Connector
STP268-EC
STP268-EC Screw Terminal Panel
Figure
J2 Connector
EP035 50-Pin
Ribbon Cable
12.
PB16H Opto-22
Backplane