Table of Contents
Advertisement
Chapter 3
Windows 2000
24
5.
When you are finished, click Close.
Once you have finished loading the device driver, perform the steps
in
Chapter 4
to attach and configure the screw terminal panel and/or
signal conditioning backplane.
Once you have installed the DT3010 Series driver from the Data
Acquisition OMNI CD, installed a DT3010 Series board, and powered
up the host computer, the New Hardware Found dialog box appears.
Perform the following steps to load the device driver in Windows
2000:
1.
Click Next.
Click Search for a suitable driver for my device (recommended).
2.
3.
Click Specify a location, and click Next.
4.
Browse to WinNT/System32/Drivers/DT3010.Inf, then click
Open.
5.
Click OK.
6.
Click Next.
The files are copied.
7.
Click Finish.
8.
Open the Control Panel.
9.
Double-click the Open Layers Control Panel icon.
10. Select the DT3010 Series board to configure, then click Advanced.
By default, the prompt "Handles Overloaded Bus?" is checked.
11. If you are using an Optiplex computer or experience timing
problems with your DT3010 Series board, uncheck this box.
12. When you are finished, click Close.
Advertisement
Table of Contents
