Table of Contents
Advertisement
Chapter 3
Loading the Device Driver
Windows 98
22
To load the DT3010 Series device driver in Windows 98, follow the
steps in the next section. To load the DT3010 Series device driver in
Windows Me, follow the steps on
device driver in Windows NT 4.0, follow the steps on
the DT3010 Series device driver in Windows 2000, follow the steps on
page
24.
Once you have installed the DT3010 Series driver from the Data
Acquisition OMNI CD, installed a DT3010 Series board, and powered
up the host computer, the New Hardware Found dialog box appears,
followed by the Add New Hardware Wizard dialog box. Perform the
following steps to load the device driver in Windows 98:
1.
Click Next.
2.
Click Search for the best driver for your device
(Recommended), then click Next.
3.
Click Specify a location, browse to the
Windows/System32/Drivers directory on your hard drive, then
click Next.
4.
Click Next.
The files are copied.
5.
Click Finish.
6.
Open the Control Panel.
Double-click the Open Layers Control Panel icon.
7.
8.
Select the DT3010 Series board to configure, then click Advanced.
By default, the prompt "Handles Overloaded Bus?" is checked.
9.
If you are using an Optiplex computer or experience timing
problems with your DT3010 Series board, uncheck this box.
10. When you are finished, click Close.
page
23. To load the DT3010 Series
page
23. To load
Advertisement
Table of Contents
