Installing The Software - Data Translation DT3010 Series Getting Started Manual

Installing the Software

This version of the Data Acquisition OMNI CD provides
WDM-compliant device drivers and DLLs (version 5.0 or greater) for
the DT3010 Series boards. Other Data Translation boards/modules
may not provide WDM-compliant drivers.
You cannot use a DT3010 Series board at the same time as another
Data Translation board/module unless both devices provide
WDM-compliant drivers.
To install the software, perform the following steps:
1. Insert the Data Acquisition OMNI CD into your CD-ROM drive.
2. Click Start from the Task Bar, then click Run.
The Run dialog box appears.
In the Command Line edit box, enter x:\LAUNCH.EXE (where x
3.
is the letter of your CD-ROM).
4. Click OK.
The Data Acquisition Software setup program starts.
5. Click Install Products.
A list of software products that you can install appears.
Click Device Drivers.
6.
The DT-Open Layers Data Acquisition software wizard appears.
7. Click Next.
You are prompted for the destination location.
8. Either change the directory path and/or name using Browse or
accept the default directory, then click Next.
You are prompted to select the software components to install.
Preparing to Use a DT3010 Series Board
CAUTION:
2
2
2
2
2
2
2
2
2
9