Transport And Storage; Installation; Electrical Connection; During Operation - Wilo -Drain TS Installation And Operating Instructions Manual

does not assume any liability for the aforemen-
tioned products.
Protective equipment: Transport, installation,
removal and maintenance
• Safety shoes: uvex 1 sport S1
• Protective gloves (EN 388): uvex phynomic
wet
Protective equipment: Cleaning work
• Protective gloves (EN ISO 374-1): uvex pro-
fapren CF33
• Safety goggles (EN 166): uvex skyguard NT
• Breathing protection mask (EN 149): Half
mask 3M series 6000 with filter 6055 A2
1.6

Transport and storage

• Wear protective equipment!
• Always carry the product by the handle!
• Clean product and disinfect if necessary!
Dirt fosters the formation of germs.
–
Encrustations may lead to the impeller be-
–
coming blocked.
1.7

Installation

• Wear protective equipment!
• Do not install damaged or defective products.
• If there is a risk of germ formation, observe
the following points:
Ensure sufficient air exchange.
–
Wear a breathing protection mask e.g. Half
–
mask 3M series 6000 with filter 6055 A2
1.8

Electrical connection

• Do not connect products with a damaged
connection cable! Have the connection cable
replaced by a qualified electrician or the cus-
tomer service.
• Mains connection with correctly installed pro-
tective earth conductor.
• Install the residual-current device (RCD) with
30 mA.
• Fuse protection at mains connection: max.
10 A.
• Product without plug: Electrical connection
must be carried out by a qualified electrician!
Installation and operating instructions • Wilo-Drain TS/TSW 32 • Ed.01/2022-07
1.9

During operation

• The pumping of highly inflammable and ex-
plosive fluids (petrol, paraffin, etc.) in their
pure form is strictly prohibited!
• If persons come into contact with the
pumped fluid (accessible basins*), do not
commission the product.
*Definition of "accessible basins"
Installation sites that can be walked on and dir-
ectly accessed without tools (examples below):
• Garden ponds
• Swimming ponds
• Cesspools
NOTICE! The specifications applicable to
swimming pools also apply to accessible
basins.

1.10 Removal

• Wear protective equipment!
• Product without plug: Have the connection
cable disconnected from the mains by a qual-
ified electrician.
• Depending on the operating mode and dura-
tion, the housing parts become hotter than
40 °C (104 °F).
Only touch the product by the carrying
–
handle.
Allow product to cool down.
–
• Clean the device thoroughly.
• If there is a risk of germ formation, observe
the following points:
Ensure sufficient air exchange.
–
Wear a breathing protection mask e.g. Half
–
mask 3M series 6000 with filter 6055 A2
Disinfect product.
–

1.11 Clean and disinfect

• Wear protective equipment!
The protective equipment prevents contact
with germs that are hazardous to health and
the disinfectant.
• If a disinfectant is used, follow the manufac-
turer's instructions!
Wear protective equipment according to
–
the manufacturer's instructions! If in doubt,
ask your specialist dealer.
en
5