Page 1
Pioneering for You Wilo-DrainLift S de Einbau- und Betriebsanleitung en Installation and operating instructions Notice de montage et de mise en service Instrucciones de instalación y funcionamiento Istruzioni di montaggio, uso e manutenzione Manual de Instalação e funcionamento Inbouw- en bedieningsvoorschriften Monterings- och skötselanvisning...
Checking the installation 6.2. Operation 6.3. Rotation direction monitoring (only for the three- phase version) 6.4. Level control 6.5. Operation 6.6. Emergency operation Shutdown/disposal 7.1. Switching off the unit 7.2. Removal 7.3. Return delivery/storage 7.4. Disposal Installation and operating instructions Wilo-DrainLift S...
• Wear You can find these here: This means the manufacturer’s liability excludes www.wilo.com/legal all liability for personal injury, material damage or financial losses. Any deviations must be contractually agreed and shall then be given priority. WILO SE 03/2016 V06 DIN A4...
2.2. General safety information protect it from moisture. Unused wires must • The lifting unit must be switched off before any be insulated! work is performed (installation, dismantling, maintenance, installation). The lifting unit must Installation and operating instructions Wilo-DrainLift S...
(with/without faeces) out of the 2.6. Fluids domestic area in accordance with EN 12056‑1. The lifting unit chiefly collects and pumps waste A grease trap must be provided if greasy sew- water containing faeces. As a result, changing to a different fluid is not possible. age is pumped! Use in drinking water is not permitted! WILO SE 03/2016 V06 DIN A4...
3.2. Set-up For exact details on connection, see the con- The Wilo-DrainLift S is a submersible, fully automatic sewage lifting unit that is ready for nection diagram in this operating and mainte- nance manual.
3.4. Operating modes 3.4.1. Operating mode S3 (intermittent operation) 3.6. Type key This operating mode involves the maximum ratio Example: Wilo-DrainLift S 1/6M RV between operating time and downtime: DrainLift Lifting unit S3 15%/120 s operating time 18 s / downtime 102 s Size Single-pump system 3.5.
For temporary storage, the lifting unit must be further details. thoroughly rinsed with clean water before storage in order to prevent encrustations and deposits building up in the collection reservoir, on the level control and the pump hydraulics. Installation and operating instructions Wilo-DrainLift S...
• Stationary dry well installation in buildings and to the unit. pump chambers • A pump sump must be arranged within the op- erating space for draining it. This must have the minimum dimensions of 500 x 500 x 500 mm. WILO SE 03/2016 V06 DIN A4...
Page 14
5.3.1. Basic advice on fixing the lifting unit have corresponding pressure resistance! Lifting units must be installed so they are pre- vented from twisting and also in an anti-buoyant fashion depending on the installation location. Installation and operating instructions Wilo-DrainLift S...
Page 15
Drill the connection for the inlet carefully. The Align the flexible connecting hose to the centre subsequent impermeability of the connection and use the enclosed pipe clasp to attach to the depends on this! flange connector and to the discharge pipeline. Max. tightening torque: 5 Nm WILO SE 03/2016 V06 DIN A4...
Page 16
For this purpose, the diaphragm hand pump can inlet pipe. However, because this is not always be permanently connected to the lifting unit. possible, the Wilo-DrainLift S has two additional Note the following: DN 40 connections: • The diaphragm hand pump must be installed at a •...
Fig. 9: Wilo-DrainLift S connection diagram tions. 1 Motor contactor • All persons working on or with the lifting unit 2 Earth terminals must have been provided with this manual and have read and understood it.
The switching points of the level control have permanent settings and cannot be adjusted. Setting the follow-up time for the pumps The pump run‑time is set at the factory for 8 sec- onds. If the slurping sound that occurs briefly at the end of the pumping process is a bother, the follow-up time can be reduced. Installation and operating instructions Wilo-DrainLift S...
• Proper protective clothing is to be worn. • When working in pump chambers, it is essential to comply with the corresponding local protective measures. A second person must be present for safety reasons. WILO SE 03/2016 V06 DIN A4...
• ½ year for units in multi-family houses of the seal. • 1 year for units in single-family houses Disconnect the connection between the non-re- turn valve and the pressure port. Installation and operating instructions Wilo-DrainLift S...
10.1. Spare parts Incorrect direction of rotation • Exchange 2 phases of the current feed ⇒ Wilo Spare parts can be ordered from Wilo customer customer service service. To avoid return queries and incorrect or- ders, the serial and/or article number must always Wear of inner parts (e.g. impeller, bearing) be supplied.
Page 23
WILO SE Nortkirchenstraße 100 44263 Dortmund Germany T +49 (0)231 4102-0 F +49 (0)231 4102-7363 wilo@wilo.com Pioneering for You www.wilo.com...
Need help?
Do you have a question about the DrainLift S and is the answer not in the manual?
Questions and answers