Post Error Message - NEC Express5800 Series Maintenance Manual

Chapter 3 Appendix
1.

POST Error Message

When an error is detected by POST, the display shows an error message. In addition, depending on the error
contents, your server might beep to report that an error occurred.
Messages indicating a memory error
(in this example, the message indicates
that CPU1_DIMM1 and CPU1_DIMM2
have failed, and that DIMM1 has been
forcibly started up)
The following table lists error messages and the actions to take in response to them.
Tips
(1) Error messages
Error Message
8000 System variable is
corrupted.
8001 Real time clock error
8002 Check date and time
settings
8003 System battery is dead
Replace and run SETUP
8005 Previous boot
incomplete - Default
configuration used
System Monitoring Check
... Passed
ERROR
AE81: CPU1_DIMM1 with error is enabled.
AE01: CPU1_DIMM1 has been disabled.
AE02: CPU1_DIMM2 has been disabled.
Press <F1> to resume, <F2> to setup
• Write down the displayed messages and beep patterns before contacting your sales
representative. Alarm messages are useful information for maintenance.
• The list only contains messages for the server. For details about error messages of
optional devices, and the actions to take, refer to the instructions that come with each
product.
Cause
Illegal setup information of BIOS was
detected.
Real time clock error was detected.
Incorrect date and time set on real
time clock was detected.
The battery for storing system
settings is dead.
The previous POST processing did
not finish.
Express5800/E120e-M Maintenance Guide
1. POST Error Message
Solution
Run BIOS Setup Utility (SETUP), and then
execute Load Setup Defaults and specify
the necessary settings.
If the same error is detected repeatedly in
spite of re-setting, contact your sales
representative.
Start SETUP, and then specify the correct
date and time.
If the same error is detected repeatedly in
spite of re-setting, contact your sales
representative.
Contact your sales representative to request
a battery replacement. (After the
replacement, start SETUP, and then specify
the correct settings.)
Run SETUP and execute Load Setup
Defaults, then specify the necessary
settings.
113