NEC Express5800 Series Maintenance Manual page 74

Chapter 2 Useful Features
Option
Check previous System
Config
BMC IRQ
Post Error Pause
Memory Error
Power Switch Inhibit
CLI SETUP
74
Parameter
[Disabled] Enable or disable the feature to detect system
configuration change.
Enabled
If this option is set to Enabled and the system
configuration differs from the previous boot, the system
stops before OS booting and displays confirmation
message whether to continue booting. At this time,
POST pauses until user's response is made.
[Disabled] Specify whether to allocate interrupt lines for BMC
(Baseboard Management Controller).
IRQ 11
Disabled Enable or disable the feature to suppress OS booting
when POST detects an error, until user's response is
[Enabled]
made.
When set to Disabled, continues OS booting
regardless of user's response even if an error is
detected during POST.
Enable or disable the feature to suppress OS booting
Halt
when POST detects a memory degradation error, until
[Boot]
user's response is made. This option is valid only when
POST Error Pause is set to Enabled. Even if this
option is set to Boot, POST stops to suppress OS
booting if all of the memory resources are degraded.
[Disabled] Enable or disable the POWER switch inhibit feature.
Enabled
[Disabled]
Enable or disable the Command Line Interface SETUP
Enabled
feature. When this option is set to Enabled, the
operation of SETUP is changed to use Command Line
Interface. To switch back to the menu operation, set this
option to Disabled from CLI SETUP.
For details of command, run HELP command at CLI
SETUP prompt. If the number of bootable devices
connected exceeds the predefined number, a message
"Failed to get Boot Variable data." is displayed on
command line and the Boot menu becomes
inaccessible. To solve this problem, disconnect USB
devices unnecessary for bootup, or change parameter
for Option ROM Scan for onboard device and/or PCI
slot to Disabled to reduce the number of bootable
devices.
Express5800/E120e-M Maintenance Guide
Descriptions
[ ]: Factory settings
1. System BIOS