NEC Express5800 Series Maintenance Manual page 122

Chapter 3 Appendix
(3) Error messages on a virtual LCD
In EXPRESSSCOPE Engine 3 web browser window, you can confirm virtual LCD error messages (for details on
the virtual LCD, refer to "EXPRESSSCOPE Engine 3 User's Guide").
The table below shows the error messages displayed on upper and lower lines, cause, and solution.
Messages displayed on an upper LCD line
Message on Upper LCD
Line
XX POST Started ...
XX BIOS Version YYYY Displayed while POST is running.
POST Completed
Successfully
POST ERROR XXXX
No Available Memory
in System
Error Pause in POST
Entering BIOS SETUP
MENU
Waiting for normal
temperature
BIOS Recovery Running BIOS recovery is in progress.
BIOS Updater Running BIOS update is in progress.
122
Cause
Displayed while POST is running.
"XX" denotes POST code that is running.
"XX" denotes POST code that is running,
and "YYYY" denotes system BIOS
version.
Displayed when POST completes
normally.
Error XXXX was detected during POST.
No available memory is installed.
POST detected an error and paused.
Starting up BIOS SETUP MENU.
A temperature abnormality was detected
inside the server.
Express5800/E120e-M Maintenance Guide
Message displayed on
upper LCD line
Message displayed on
lower LCD line
Solution
This is not an error.
This is not an error.
This is not an error.
Check the message displayed on LCD, and take
an appropriate action.
Make sure that the memory is correctly installed.
If the same message is displayed repeatedly,
contact your sales representative.
Check the message displayed on LCD, and take
an appropriate action.
This is not an error. This message will disappear
when SETUP operation is completed.
Lower the room temperature or turn off the power
to cool the server to room temperature before
starting up the server. If this abnormality continues
to occur, check if a fan has failed. If the same error
still continues to occur, contact your
representative.
This is not an error. Wait until BIOS recovery is
completed.
This is not an error. Wait until BIOS update is
completed.
1. POST Error Message