NEC Express5800 Series Maintenance Manual page 117

Chapter 3 Appendix
Error Message
AE8A CPU2_DIMM4 with error is
enabled.
AE8B CPU2_DIMM5 with error is
enabled.
AE8C CPU2_DIMM6 with error is
enabled.
B000 Expansion ROM not
initialized
B001 Expansion ROM not
initialized - PCI
Slot 01
B002 Expansion ROM not
initialized - PCI
Slot 02
B022 Serial Port
Configuration
Overlapped.
B030 PCI System Error on
Bus/Device/Function
B040 PCI Parity Error on
Bus/Device/Function
B201 Onboard LAN 1 – PCIe Link
Failure
B202 Onboard LAN 2 – PCIe Link
Failure
B211 PCI Slot 1 – PCIe Link
Failure
PCI Slot ２ – PCIe Link
B212
Failure
B221 Onboard LAN 1 – PCIe Link
Width Error
B222 Onboard LAN 2 – PCIe Link
Width Error
B231 PCI Slot 1 - PCIe Link
Width Error
B232 PCI Slot 2 - PCIe Link
Width Error
B261 Onboard LAN 1 – PCIe Link
Speed Error
B262 Onboard LAN 2 – PCIe Link
Speed Error
B271 PCI Slot 1 - PCIe Link
Speed Error
Cause
An error in CPU2_DIMM4 was
detected, but because all memory is
currently disabled, this DIMM was
forcibly enabled.
An error in CPU2_DIMM5 was
detected, but because all memory is
currently disabled, this DIMM was
forcibly enabled.
An error in CPU2_DIMM6 was
detected, but because all memory is
currently disabled, this DIMM was
forcibly enabled.
Failed to expand option ROM.
Option ROM expansion in PCI slot 1
failed.
Option ROM expansion in PCI slot 2
failed.
Overlapping serial port configuration
was detected.
PCI SERR was detected.
PCI PERR was detected.
Connection failure of PCIe bus was
detected on onboard LAN1.
Connection failure of PCIe bus was
detected on onboard LAN2.
Connection failure of PCIe bus was
detected on PCI slot 1.
Connection failure of PCIe bus was
detected on PCI slot 2.
PCIe bus width error was detected
on onboard LAN1.
PCIe bus width error was detected
on onboard LAN2.
PCIe bus width error was detected
on PCI slot 1.
PCIe bus width error was detected
on PCI slot 2.
PCIe bus speed error was detected
on onboard LAN1.
PCIe bus speed error was detected
on onboard LAN2.
PCIe bus speed error was detected
on PCI slot 1.
Express5800/E120e-M Maintenance Guide
1. POST Error Message
Solution
Contact your sales representative.
Disable expansion of option ROM of the
board that is not used for OS boot.
Disable expansion of option ROM of the
option board that is not used for OS boot.
Run SETUP, and select Advanced → PCI
Configuration → PCI Device Controller
and Option ROM Settings → PCIxx Slot
Option ROM → Disabled. (xx: PCI slot
number)
Start SETUP, select Advanced → Serial
Port Configuration, and specify the setting
again in a way that the values of Base I/O or
Interrupt in Serial Port A and Serial Port B
will not be the same.
Contact your sales representative.
117