E
Et0l
Command
Control Parameters
Control para. sets
Tv manual/auto
Correction limitation
Pump
Menu
74
Parameter Slave controller (P-controller):
Sl proportional range:
Tve, Tde, Prop_E changeover to Auto/ Man
E
Works setting is automatic. These three parameters should only be
A
°C
modified by experienced control technicians!
Hold
Correction limitation Et0l See introduction ( 7.13.2).
°C
Kpe
Tne
Tve (auto) 83
Tde (auto)
Xpf
Prop_E(a)
End
T
Proline Edition X cooling thermostats
A = automatic or E
pressed for 3 seconds, then make changes.
Parameters
Open the device parameter menu via the
0,50
100
With the cursor keys continue to
8,3
4,0
30
The adjacent window appears.
Where applicable change parameters
T
set
fix
Select the parameters to be changed with
Then change the value in the following
Starting up
iP
= Xpf
MN = manual.
Control Control Parameters Control
soft key
Menu
Control
Control Parameters
Control Parameters
Parameter endings:
e = Master controller, f = Slave controller.
marked with (auto) to manual input with
Tv manual/auto
.
and confirm with
settings window and confirm with
Correction limitation
( 7.13.2).
YACE0100 / October 4, 2018
in Kelvin.
.
.
.
.
see introduction