Forward, Reverse, And Acceleration - TOHATSU MFS 25D Owner's Manual

48
ENGINE OPERATION
and trolling speed is set to 850 min
( r p m ) w h e n t h e e n g in e sp e e d is
increased above 3,000 min
after the engine restarted.
If battery voltage is lower than specified
value, this function does not operate, and
trolling speed is controlled to 850 min
(rpm) automatically.
ENOM00046-A
4. Forward, reverse, and
acceleration
ENOW00037-1
Before shifting into forward or reverse, make
sure that boat is properly moored and out-
board motor can be steered fully to the right
7
and left. Make sure that no swimmer(s) is
around of the boat.
ENOW00967-0
Attach the other end of emergency stop
switch lanyard to the operator's PFD (Per-
sonal Flotation device) or arm and keep it
attached during cruising.
Do not attach the lanyard to a part of
clothing that can be torn easily when
pulled.
Arrange the lanyard so that will not be
caught by any object when pulled.
Be careful not to pull the lanyard acciden-
tally during cruising. Unintentional stop of
engine can cause loss of control of out-
board motor. Rapid loss of engine power
can lead to fall down or causing passen-
ger(s) to be thrown overboard.
ENOW00042-1
Do not shift into Reverse during planing,
or control will be lost leading to serious
-1
(rpm) or
WARNING
WARNING
WARNING
-1
personal injury, boat may swamp, and/or
hull may be damaged.
Do not shift into Reverse during cruising,
or control may be lost, fall down or caus-
ing passenger(s) to be thrown overboard.
Leading to serious personal injury, and
steering system and/or shifting mecha-
-1
nism may be damaged.
ENOW00861-1
Do not shift at high boat speed, or control
may be lost, fall down or causing passen-
ger(s) to be thrown overboard. Leading to
serious personal injury.
ENOW00867-1
Sudden acceleration and deceleration may
cause passenger(s) to be thrown overboard
or fall down.
ENOW00862-1
Gear and clutch damage may occur if shifting
at high engine speed.
Engine must be in the slow idle position
before shifting.
ENOW00863-0
Idle speed may be higher during warming up
of engine. If shifted to Forward or Reverse
during warming up, it may be difficult to shift
back to neutral. In such case, stop engine,
shift to neutral, and restart engine to warm
up.
ENON00014-0
Note
Frequent shifting to forward or reverse can
accelerate wear or degradation of parts. In
such case, replace gear oil earlier than the
period specified.
WARNING
WARNING
CAUTION
CAUTION