TOHATSU MFS 25D Owner's Manual page 27

ENOW00945-0
CAUTION
Please inspect whether there is a loosen-
ing of the clamp screw or mounting bolts
before departure.
Loosening may cause a dangerous situa-
tion, such as loss of control.
PT type
1. Set the outboard motor to appropri-
ate position.
2. Secure the clamp brackets to the
transom board using bolts, flat wash-
ers and nylon locking nuts.
1
2
1. Bolt (12 × 105)
2. Washer (small diameter)
3. Nylon locking nut
4. Washer (large diameter)
ø12.5
ENOW00008-2
Install upper mounting bolts from the
boat side. Exposing threaded side of bolts
on the boat side can casue personal
injury.
Tighten the bolts securely, otherwise the
outboard motor could fall down.
4
ENON00948-0
Note
3
ENOF00612-A
INSTALLATION
327
(12.9")
ø12.5
251
(9.9")
CAUTION
Apply sealing agent, such as silicone
sealant between the bolts and the
transom board holes before tightening
the bolts.
Do not reuse nylon locking nut.
27
5
ENOF00613-0