TOHATSU MFS 25D Owner's Manual page 75

ENOM00091-A
Engine oil replacement
ENOW00091-1
CAUTION
You may be injured due to high engine tem-
peratures if you fill engine oil just after oper-
ation. Engine oil should be changed after the
engine has been cooled.
ENOW00092-1
CAUTION
Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper limit
marks of dip stick, drain oil to level lower
than upper limit.
Be sure that outboard motor is upright
when checking or changing oil.
Stop the engine immediately if low oil
pressure warning lamp or oil leak is found,
or engine could be severely damaged.
Consult your dealer.
Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
ENOW00090-0
CAUTION
Use of engine oils that does not meet these
requirements will result in reducing engine
life, and other engine problems.
ENOW00933-0
CAUTION
Engine oil mixed with dust or water will dra-
matically shorten the life of the engine.
INSPECTION AND MAINTENANCE
ENOM01906-0
To change engine oil:
Be sure to use recommended engine oil.
1. Stop the engine and leave it in a verti-
cal position over 5 minutes.
2. Put an oil drain pan under the oil drain
bolt.
3. Remove the oil drain bolt and com-
pletely drain oil from the engine.
1
1. Drain hole
4. Apply oil on the sealing surface of the
drain bolt. Tighten the bolt with a new
gasket.
Oil drain screw specified torque
·
24 N·m (17 ft lb, 2.4 kgf
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn past
finger-tight. Have the oil filter adjusted to
the correct torque as soon as possible with
a torque-wrench.
5. Pull the bottom of cowl latch to
unlock, lift and remove the top cowl.
75
ENOF02552-0
10
·
m)