Engine Operation; Before Starting; Fuel Feeding - TOHATSU MFS 25D Owner's Manual

38

ENGINE OPERATION

ENOM00042-0

Before starting

ENOM00246-0
Oil Level checking
Check the engine oil level before each
use. If the oil level is low or too high, the
life of the engine will be shortened sig-
nificantly. (To properly check the engine
oil level, follow the instructions,
68)
1
7
1. Filler cap
2. Dipstick
3. Filler port
1. Upper limit
2. Lower limit
see page
2
3
ENOF02510-0
1
2
ENOF02511-0
ENOW00027-B
CAUTION
Before starting engine for the first time after
reassembling engine or off-season storage,
disconne c t stop switch lock and crank
approximately 10 times in order to prime the
oil pump.
ENOM01900-0

1. Fuel feeding

ENOW00029-1
WARNING
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out if the fuel tank cap is opened
by using another procedure when internal
pressure of fuel tank is raised by heat from
sources such as sun light.
ENOW00030-B
WARNING
When using EPA approval fuel tank, only use
a primer bulb/hose assembly that has a Fuel
Demand Valve (FDV) installed in the fuel hose
or a sealing mechanism in the fuel connector
as shown below.
FDV and fuel connector that has an sealing
mechanism prevent pressurized fuel spillage
when the fuel connector is connected to the
engine.
1
1. FDV in fuel hose
2. Sealing mechanism in fuel connector
3. Identification
Do NOT use a primer bulb/hose assembly
that does not contain a Fuel Demand Valve or
2
3
ENOF00035-0