TOHATSU MFS 25D Owner's Manual page 68

68
INSPECTION AND MAINTENANCE
Item
Steering
Devices
Other parts
ENOM01905-0
Oil level checking
If the oil level is low, or too high, the life
of the engine will be shortened signifi-
cantly.
1. Stop the engine and place the out-
board motor in a vertical position.
2. Pull the bottom of cowl latch to
unlock, lift and remove the top cowl.
3. After the engine has been shut off 5
minutes, remove the dipstick and
wipe oil off with a clean cloth.
4. Insert the dipstick to the hole com-
pletely.
5. Remove the dipstick. Oil level must be
between the upper limit and lower
limit shown on the dipstick.
6. If the oil level is below the lower limit,
add the oil to between the upper and
lower limit mark on the dipstick.
10
1
1. Filler cap
2. Dipstick
3. Filler port
Points to Check
• Make sure that steering handle and remote control is
functioning normally.
• Check if the anode is securely installed.
• Check the anode for corrosion and deformation.
2
3
ENOF02510-0
1. Upper limit
2. Lower limit
ENON00024-0
Note
The oil level should be checked when the
engine is cooled.
ENON00025-0
Note
Consult with an authorized dealer if the
engine oil is milky color, or appears con-
taminated.
ENOM00082-A
Engine oil replenishing
ENOW00079-A
CAUTION
Do not add engine oil of brand and grade
other than existing one. In case engine oil
of other brand or grade is added, drain all
oil and ask dealer for treatment.
In case other than engine oil such as gaso-
line is put in the oil chamber, empty the
chamber and ask dealer for treatment.
When replenishing engine oil, be careful
not to allow entry of foreign matters such
as dust and water into oil chamber.
Remedy
Repair
Repair if necessary
Replace
1
2
ENOF02511-0