TOHATSU MFS 25D Owner's Manual page 62

62
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENOW00071-0
CAUTION
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
When transporting a boat on a trailer
with the outboard motor attached, dis-
connect the fuel line from the outboard
motor beforehand and keep the out-
board motor in the vertical or on a tran-
som saver bar.
Tiller handle type
While transpor ting outboard motor
attached to the boat on a trailer, properly
tighten the steering friction bolt to pre-
vent the outboard motor from moving.
(page 63).
8
2
1
ENOF00074-A
1. Ground clearance should be provided
sufficiently.
2. Transom saver bar
ENOW00067-0
WARNING
Do not go under outboard motor tilted up
even if it is supported by support bar, or
accidental fall of outboard motor could lead
to severe personal injury.