TOHATSU MFS 25D Owner's Manual page 71

ENOM00085-E
Flushing hose joint
ENOW00921-0
CAUTION
Do not operate the engine when flushing the
outboard motor with a hose joint as this can
cause damage to the outboard motor.
ENOW00922-0
CAUTION
To prevent the engine from starting when
you are near the propeller, remove the stop
switch lock.
1. Tilt down the outboard motor.
2. Remove the flushing connector cap
from the outboard motor, and screw
in the hose joint.
3. Connect a water hose. Turn on the
water and adjust the flow.
Continue flushing the outboard motor
for 3 to 5 minutes
4. After the flushing, be sure to reattach
the flushing connector cap.
5. Tilt up the outboard motor.
.
1. Flushing connector cap
2. Hose joint
1
2
ENOF02531-0
INSPECTION AND MAINTENANCE
ENOM00085-A
Flushing by test tank
ENOW00081-1
WARNING
Do not start engine without removing pro-
peller, turning propeller out in the open may
lead to personal injury.
ENOW00082-0
WARNING
Never start or operate the engine indoors or
in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be fatal
if inhaled for any length of time.
ENOW00036-1A
CAUTION
When starting the outboard motor in the
test tank, make sure that:
1. Water level is at least 10 cm (4 in.) above
the anti-ventilation plate to avoid over-
heating of the engine.
2. Run at idling only
3. Remove the propeller
81
(See page )
3
2
1. Test tank
2. Water
3. Over 10 cm (4 in.)
71
10
1
ENOF00863-0