Maintenance And Cleaning; Disposal; Technical Data - Conrad 750987 Operating Instructions Manual

Surveillance camera with image memory

Table of Contents

Available languages

15. Maintenance and cleaning

Before cleaning the housing of the surveillance camera, separate it from the mains voltage and backup the data of

the internal memory if applicable.

Wait until the housing has cooled down (danger of burns!)

To clean the outside of the product, a dry, soft and clean cloth is sufficient. For stronger contamination of the exterior,

you can moisten the cloth slightly with lukewarm water.

Clean the camera lens and the surface of the PIR sensor very carefully to prevent scratches.

Electric and electronic products must not be disposed of in the domestic waste.

At the end of its service life, dispose of the product according to the relevant statutory regulations.

Operating voltage: ............................... 230 V/AC, 50 Hz

PIR angle: ............................................ 52°

PIR range: ............................................ up to 9 m

Sensor inside the camera: .................. 1.3 megapixels, CMOS; video resolution 320x240 pixels, 10 frames/s

Camera angle: ..................................... 48°

Internal memory: .................................. 16MByte (not fully available, required by the camera electronics)

External memory: ................................. SD slot, up to 2GB

Light source: ........................................ R7S, max. 500 W

Operating temperature: ....................... -10 °C to +40 °C

Storage temperature: .......................... -20 °C to +55 °C

Air humidity during operation/storage: 20 - 85% (non-condensing)

Table of Contents

Table of Contents