Routing Commands; Services Commands - Lantronix SecureLinx SLC8 User Manual

service <none|telnet|ssh|tcp>
sshauth <enable|disable>
sshport <TCP Port>
stopbits <1|2>
tcpauth <enable|disable>
tcpport <TCP Port>
telnetauth <enable|disable>
telnetport <TCP Port>
timeoutlogins <disable|1-30>
Description
Configures a currently loaded PC Card.

Routing Commands

set routing
Syntax
set routing [parameters]
Parameters
rip <enable|disable>
route <1-64> ipaddr <IP Address> mask <Netmask> gateway <IP Address>
static <enable|disable>
version <1|2|both>
Description
Configures static or dynamic routing.
To delete a static route, set the IP address, mask, and gateway parameters to 0.0.0.0.
show routing
Syntax
show routing [resolveip <enable|disable>] [email <Email Address>]
Description
Sets the routing table to display IP addresses (disable) or the corresponding host names
(enable). You can optionally email the displayed information.

Services Commands

set services
Syntax
set services <one or more services parameters>
Parameters
alarmdelay <1-6000 Seconds>
SecureLinx SLC User Guide
14: Command Reference
243