Port Status And Counters; Device Ports - Slp - Lantronix SecureLinx SLC8 User Manual

b) In to Device Ports, type the device port numbers, separated by commas;
Note:
ports.

Port Status and Counters

Port Counters describe the status of signals and interfaces. SLC updates and increments
the port counters as signals change and data flows in and out of the system. These
counters help troubleshoot connections or diagnose problems because they give the user
an overview of the state of various parameters. By setting them to zero and then re-
checking them later, the user can view changes in status.
The chart in the middle of the page displays the flow control lines and port statistics for
the device port. The system automatically updates these values. To reset them to zeros,
select the Zero port counters checkbox in the IP Settings section of the page.
Note: Status and statistics shown on the web interface represent a snapshot in time. To
see the most recent data, you must reload the web page.
Device Ports – SLP
On the Device Ports – SLP page, configure commands to send to an SLP or SLP
expansion chassis that expands the number of power ports.
To open the Device Ports – SLP page:
1. In the Connected to field above the IP Settings section of the Device Ports –
Settings page, select an SLP or SLPEXP.
2. Click the Device Commands link. The following page displays:
SecureLinx SLC User Guide
indicate a range of port numbers with a hyphen (e.g., 2, 5, 7-10).
It may take a few minutes for the system to apply the settings to multiple
8: Devices
83