Mapping A Rule Set; Ip Filter Commands - Lantronix SecureLinx SLC8 User Manual

Mapping a Rule Set

The administrator can assign an IP Filter Rule Set to a network interface (Ethernet
interface), a modem connected to a Device Port, or a PC Card modem.
To map a rule set to a network interface:
1. On the IP Filter page, select the IP filter rule set to be mapped.
2. From the Interface drop-down list, select the interface and click the Map Ruleset
button. The Interface and rule set display in the IP Filter Mappings table.
To delete a mapping:
1. On the IP Filter page, select the mapping from the list and click the Delete
Mappings button. The mapping no longer displays.
2. Click the Apply button.

IP Filter Commands

The following CLI commands correspond to the web page entries described above.
To enable or disable IP filtering for incoming network traffic:
set ipfilter state
To set IP filter mapping:
set ipfilter mapping <parameters>
Parameters:
To set IP filter rules:
set ipfilter rules <parameters>
Parameters:
SecureLinx SLC User Guide
ethernet <1|2> state <disable>
ethernet <1|2> state <enable> ruleset <Ruleset Name>
deviceport <1..48> state <disable>
deviceport <1..48> state <enable> ruleset <Ruleset
Name>
pccardslot <upper|lower> state <disable>
pccardslot <upper|lower> state <enable> ruleset
<Ruleset Name>
add <Ruleset Name>
delete <Ruleset Name>
edit <Ruleset Name> <Edit Parameters>
Edit Parameters:
append
insert <Rule Number>
replace <Rule Number>
delete <Rule Number>
6: Basic Parameters
51