Email/Snmp Notification; Sylog Logging - Lantronix SecureLinx SLC8 User Manual

Email/SNMP Notification

The system administrator can configure the SLC to send an email alert message
indicating a particular condition detected in the device port log to the appropriate parties
or an SNMP trap to the designated NMS (see
when a user-defined number of characters in the log from your server or device is
exceeded, or a specific sequence of characters is received.
Use the Device Ports – Logging page to set logging parameters on individual ports.

Sylog Logging

Data can be logged to the system log. If this feature is enabled, the data will appear in
the Device Ports log, under the Info level. The log level for the Device Ports log must be
set to Info for the data to be saved to the system log. (See
To set logging parameters:
1. In the top section of the Device Ports – Settings page, click the Settings link in the
Logging field. The following page displays:
2. Enter the following:
Local Logging
Local Logging
SecureLinx SLC User Guide
7: Services). The email or trap is triggered
If you enable local logging, each device port stores 256
Kbytes (approximately 400 screens) of I/O data in a true
FIFO buffer. Disabled by default.
8: Devices
7: Services.)
91