Ametek mocon Dansensor MAP Mix ProVectus User Manual page 36

34 User Guide
No.
85*
86
87*
88
95
96
97
100
P/N 300862-K
11/2019
Type Message
Warning Device temperature very low
Error Device temperature too low
Warning Device temperature very high
Error Device temperature too high
Warning A X-gas mixer is connected, must be X-gas
Error Mixer high pressure alarm on gas input X
Warning Pressure alarm on mixer X gas input X
Warning Cannot bridge to a mixer with older software version
EN Dansensor MAP Mix Provectus
®
User action
Place unit in
temperature
above 0 °C
Allow unit to
heat up
Place unit in
temperature
above 0 °C
Allow unit to
heat up
Check cooling/
filters
If error persist,
contact service
Check cooling/
filters
If error persist,
contact service
Check settings
Slave mixer must
have same
number of
gasses and types
as Master mixer.
Input pressure
over 10.5 bar
Adjust input
pressure to less
than 10 bar
Check gas supply
Use mixer with
compatible SW
version