Ametek mocon Dansensor MAP Mix ProVectus User Manual page 35

Dansensor MAP Mix Provectus
®
No. Type
26 Error
27 Error
28 Error
32 Error
33 Error
34 Error
35 Error
36 Error
58 Error
59 Error
60 Error
61 Error
62 Warning
63 Error
71 Error
72 Error
73 Error
74 Error
75 Error
76 Error
77 Error
78 Error
80 Error
81 Error
EN
Message
Import/Export: no data found
Import/Export: corrupted data
Import/Export failed
Unknown error from STM
Error from STM
Error from STM
Internal communication error
Internal communication error
Fan speed too low, check if fan is functional
Error in fan parameters, running fan at full speed.
Temperature sensor not calibrated. Device
temperature may not be valid.
Cannot start mixer: invalid mixer parameters.
Mixer is not calibrated
Mixer could not reach requested flow
Cannot establish connection to external mixer
Data log network dump failed: cannot connect to
server
Data log network dump failed: connection to server
was lost
Data log network dump failed: no ACK received
Data log network dump failed: wrong ACK received
Mixer low pressure alarm on gas input X
Error from slave mixer
Configured flow over maximum possible
Cannot start mixer: flow under minimum
Pressure alarm on gas input X
User Guide
User action
User information
User information
User information
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Check cooling/
filters
If error persists,
contact service
User information
Contact service
for calibration
Check that the
inlet pressure is
OK
(2-10 bar)
User information
Check LAN
connection
Check LAN
connection
Check LAN
connection
Check LAN
connection
User information
User information
User information
User information
User information
P/N 300862-K
11/2019
33