Jam; Jam - Canon STAPLER SORTER-L1/MS-C1 Service Manual

CHAPTER 2 OPERATIONS AND TIMING
D. Jam
When the sorter judges a jam, it sends a jam signal (SJAM) to the copier. In response to the
signal, the copier stops its operation and, at the same time, causes the control panel to light the JAM
indicator.
After the jam is detached and the COPY START KEY is pressed again, the number of sheets of
paper corresponding to the jammed ones is automatically copied and delivered to the bins.
If a jam occurs in the copier, all of the copies being moved through the sorter to the bins are fed
to the specified bins and then the operation stops.
Sorter
Bin
Paper detection
Reference:
If a jam occurs in the sorter, open the copier, remove the jam, and close the copier to reset.
1. Feed delay jam
When the paper detection sensor detects no paper even though the feed time corresponding to
the time required to feed the paper of 350mm (which varies depending on the copiers) has elapsed
after the copier receives the delivery signal from the copier.
2-24
COPYRIGHT © 1998 CANON INC. CANON STAPLER SOTRER-L1 MS-C1 REV.0 NOV. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Feed roller
sensor (PI5)
Figure 2-304
Copier paper
delivery signal
Feed motor(M2)
Paper detection
sensor(PI5)
Jam signal(SJAM)
*Time required to feed paper for 350mm
(varies depending on copier type)
Figure 2-305
Copyer
roller
Upper guide
roller
Lower guide
*
a a
Normal
Copy paper
Paper delivery roller
*
Abnormal