Canon STAPLER SORTER-L1/MS-C1 Service Manual page 82

CHAPTER 3 MECHANICAL SYSTEM
2. Positioning the Lead Cam
1) Remove the screw [4], Remove the screw
and remove the adjusting plate [2] and the
parallel pin [3] which secure the lead cam
drive gear [1] at the front in place.
2) Adjust the engagement of the lead cam
drive gear [1] so that the reference
markings (R-R or F-F) at the front/rear
match as shown. (Turn the front and rear
lead cams in the direction in which the bin
unit moves up.)
3) Pull the shaft [5] to the front so that the
play of the lead cam drive gear [1] is
minimum; then, fix the adjusting plate [2]
in place by butting it against the gear.
3-6
COPYRIGHT © 1998 CANON INC. CANON STAPLER SOTRER-L1 MS-C1 REV.0 NOV. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
[4]
[5]
Figure 3-209
Match
Match
R
mark mark
Figure 3-210
[1]
[2] [3]
Match
Match
R
mark mark