Unit; Stapler Swing Unit; Unit Swing Motor (M1) - Canon STAPLER SORTER-L1/MS-C1 Service Manual

CHAPTER 5 TROUBLESHOOTING
4. Adjusting the stapler unit swing position
(Adjusting the stapling position)
Make these adjustments whenever you have replaced the following parts. (If you have replaced
the sorter controller PCB, be sure to adjust the guide bar swing range first.)
• Sorter controller PCB
• Stapler unit
• Stapler unit swing motor (M1)

• Stapler swing unit

Procedure
1) Remove all the copies in the bin unit and detach the rear cover.
2) Set the dip switch (SW3) on the sorter controller PCB as shown below.
* The No.6 switch is used for switching the communication method with the copier and should not be
moved.
3) Place about 5 copies of A4 or LTR size into the top bin.
4) Press the push switch (SW1) on the sorter controller PCB and move the stapler swing unit to
the stapling position. Each press on the push switch (SW1) moves the swing position to the
rear by 0.5 mm.
5-6
COPYRIGHT © 1998 CANON INC. CANON STAPLER SOTRER-L1 MS-C1 REV.0 NOV. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
ON
1 2 3 4 5 6
Figure 5-106
A4/LTR
Figure 5-107
SW3
*
ON
1 2 3 4 5 6
Figure 5-108
*
SW2 SW1
Stapling Foward