Table of Contents
Advertisement
1.1.2
Flush mounting
Referring to the figure below, select a flat mounting location. Read the installation in-
structions before starting. Pay particular attention to the notes; failure to follow these
instructions may cause damage to the unit.
Note: Ensure the mounting location is flat, with no indents or protrusions, to allow a
secure fit.
1. Place the unit face-down on a soft/clean surface, then unfasten the knob bolts on
either side of the unit.
Knob bolt
2. Separate the hanger from the unit. If the hanger does not release easily, gently
move the arms of the hanger outwards as you separate it from the unit.
3. Prepare a cutout in the mounting location using the template (supplied) for the
TZT9F.
4. Fasten the wing bolts and the wing nuts of the flush mount fixture so that the pro-
tector for screw moves to the flush mount fixture.
Flush mount fixture
Note: Slowly fasten the four wing bolts evenly with your hand. Do not use a tool
to fasten the wing bolts. A tool can be used to fasten the wing nuts; use caution
so as not to damage the wings or thread.
Flat
Wing nut
Curved
Hanger
Wing bolt
Flush mount fixture
Protector for screw
Move to the fixture
1. MOUNTING
Bumpy
Knob bolt
1-3
Advertisement
Table of Contents
