Table of Contents
Advertisement
Menu item
[Fluid Instance]
Select the NMEA instance for the tank.
[Self test]
Test results are displayed.
[Set Hardware to
Resets the converter selected at
Factory Default]
[Select IF] to factory default.
[Initial Setup] menu - [DATA ACQUISITION]
Menu Item
[GP330B WAAS Mode]
[WS200 WAAS Mode]
[Data Source]
[Sensor List]
[NMEA0183 Output]
Note: If the TTM sentence
is received at the same
time as another sentence,
the constraints to commu-
nication bandwidth may
cause a decrease in the
number of TTM targets.
[NMEA2000 PGN Output]
[Sky View]
[Initial Setup] menu - [NMEA2000 LOG]
Menu Item
[Enable NMEA2000 Log]
[NMEA2000 Log Storage
Location]
[Initial Setup] menu - [INTERNAL GPS SETUP]
Menu Item
[WAAS Mode]
[Initial Setup] menu - [SC-30 SETUP]
This menu is only available with SC-30 connection.
Menu item
[WAAS Mode]
Select [ON] to use the WAAS mode.
[Heading Offset]
Enter the offset value for heading.
[Pitch Offset]
Enter the offset value for pitching.
[Roll Offset]
Enter the offset value for rolling.
Description
Description
Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. The FURUNO products are shown at the upper part of the list.
Show the information for sensors connected to your equipment. Also,
you can set "Nickname" for them here.
[Port Configuration] - [Baud Rate]: Select
the output baud rate.
[Port Configuration] - [NMEA-0183 Ver-
sion]: Select the NMEA0183 version for
output.
[Sentences]: Select the sentences to out-
put.
Select [ON] for the PGN's (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
Note: The default setting of some PGNs is "ON".
Show the condition of GPS and GEO (WAAS) satellites. Number, bear-
ing and elevation angle of all GPS and GEO satellites (if applicable) in
view of your GPS receiver appear.
Description
Set to [ON] when using NMEA2000 log.
Show the location where to store the log.
Description
Set to [ON] to use the WAAS mode.
Description
3. HOW TO SET UP THE EQUIPMENT
Options (setting range)
[000] to [254]
[OK], [Cancel]
Options (setting range)
[ON], [OFF]
[4,800], [9,600], [38,400]
[1.5], [2.0], [3.0]
[ON], [OFF]
Options (setting range)
[ON], [OFF]
Options (setting range)
[ON], [OFF]
Options (setting range)
[ON], [OFF]
-180° to +180°
-90° to +90°
-90° to +90°
3-9
Advertisement
Table of Contents
