Table of Contents
Advertisement
3. HOW TO SET UP THE EQUIPMENT
[Radar] menu - [Antenna Position]
Menu item
[Longitudinal (from bow)]
[Lateral (-Port)]
[Antenna Height]
[Auto Tuning]
[Tuning Source]
[Manual Tuning]
[Radar Monitoring]
[Radar Optimization]
[ARPA Advanced Settings]
[TX Channel]
[Target Analyzer Mode]
[Auto acquire by Doppler]
[Set Hardware to Factory
Default]
[Reset Default Settings]
3-14
Description
Referring to the figure on the right,
enter the radar antenna position-
ing bow-stern (Longitudinal) and
port-starboard (Lateral) position
from the origin.
Select the height of the antenna above the
waterline. Not available (greyed out) with
the radar sensor DRS4DL+.
Enable/disable auto tuning for the connect-
ed radar. Not available (greyed out) with
DRS2D-NXT, DRS4D-NXT.
Select a display in the dual range display to
manually tune. Not available (greyed out)
with the radar sensor DRS2D-NXT,
DRS4D-NXT, DRS4DL+.
Manually tune the radar.
Display various information regarding the connected radar.
Automatically adjust magnetron output and tuning for the connected
radar. Available when the [TX/STBY] setting is [ON]. Do not change
these settings. Not available (greyed out) with the radar sensor
DRS2D-NXT, DRS4D-NXT.
Note 1: For the service technician only.
Note 2: The service technician performs this whenever the magnetron
is replaced.
For service technician only. Do not change these settings.
This item is available when [TX/STBY] is [ON].
Not available (greyed out) with the radar sensor DRS4DL+, and FAR-
2xx8 series, FAR-2xx7 series and FAR-15x8 series radar antennas.
Select [1], [2] or [3], the channel where the
interference is smallest. See the operator's
manual for details. Available with the radar
sensor DRS2D-NXT, DRS4D-NXT.
You can emphasize rain clutter or target
echoes when the target analyzer is active.
Select [Rain] or [Target] as appropriate.
See the operator's manual for details.
Available with the radar sensor DRS2D-
NXT, DRS4D-NXT, DRS6A-NXT and
DRS12A-NXT.
When selecting [ON], approaching targets
(ships, rain clutter, etc.) within 3 NM from
own ship are automatically acquired by the
Doppler calculated from the radar echo.
See the operator's manual for details.
Available with the radar sensor DRS2D-
NXT, DRS4D-NXT, DRS6A-NXT and
DRS12A-NXT.
Resets the radar selected at
[Radar Source] to factory default.
Resets [Radar] menu settings to default.
Options (setting range)
[0] m to [999] m
[-99] m to [+99] m
Port-side is negative,
Origin
Origin
Starboard-side is posi-
tive.
[Under 3m], [3m-10m],
[Over 10m]
[ON], [OFF]
[Range1], [Range2]
[-50] to [50]
[Auto], [1], [2], [3]
[Rain], [Target]
[ON], [OFF]
[OK], [Cancel]
[OK], [Cancel]
Advertisement
Table of Contents
