Table of Contents
Advertisement
3. HOW TO SET UP THE EQUIPMENT
[Initial Setup] menu - [NETWORK SENSOR SETUP]
The [NETWORK SENSOR SETUP] section allows you to set up compatible FURUNO
NMEA2000 sensors. Calibrations and offsets applied in this menu are also applied to
the sensor itself.
Tap the sensor to access its menus and settings. For details regarding the menu struc-
ture and set up of each sensor, see the operator's manual supplied with the sensor.
[Initial Setup] menu - [CALIBRATION]
Menu item
[Heading]
Offset heading data.
[Speed Through
Calibrate speed data. Enter amount in percentage.
Water]
[Wind Speed]
Offset wind speed data. Enter amount in percentage. -50% to +50%
[Wind Angle]
Offset wind angle data.
[Sea Surface
Offset sea surface temperature data.
Temperature]
[Initial Setup] menu - [DATA DAMPING]
Menu item
[COG & SOG]
[Heading]
[Speed Through Water]
[Wind Speed & Angle]
[Rate of Turn]
[Initial Setup] menu - [FUSION]
Menu item
[Connect to Fusion]
[Fusion Auto Volume]
[Minimum Speed]
[Maximum Speed]
[Volume Increase]
[Initial Setup] menu - [BROWSER INSTALLATION]
Menu item
[FAX30 Browser]
[FA30 Browser]
[FA50 Browser]
3-10
Description
Description
Set data damping time. The lower the setting
the faster the response to change.
Description
Connects to your Fusion equipment.
Set to [ON] to allow the TZT9F to control the
FUSION volume. Volume is adjusted ac-
cording to vessel speed.
Set the minimum speed threshold. Exceed-
ing this speed activates volume auto control.
Set the maximum speed threshold.
Set the amount of extra volume to output
when the vessel reaches the [Maximum
Speed] setting.
Description
Show the Facsimile Receiver FAX-30 display.
Show the AIS Receiver FA-30 display.
Show the AIS Receiver FA-50 display.
Options (setting range)
-180.0° to +180.0°
-50% to +50%
-180° to +180°
-10°C to +10 °C
Options (setting range)
0 to 59 (seconds)
Options (setting range)
[ON], [OFF]
0.0 (kn) to 98.9 (kn)
0.1 (kn) to 99.0 (kn)
10% to 50%
Option (setting range)
Advertisement
Table of Contents
