Table of Contents
Advertisement
Source language: German
EU Declaration of conformity
We declare under our sole responsibility that this product corresponds to the directives 2014/35/EU,
2006/42/EC, 2014/30/EU and 2011/65/EU and conforms with the following standards or nor-
mative documents: EN 61010-1, EN 61010-2-051, EN 61326-1, EN 60529 and EN ISO 12100.
A copy of the complete EU Declaration of Conformity or further declarations of conformity can
be requested at sales@ika.com.
Explication of warning symbols
/// Warning symbols
Danger!
Indicates an (extremely) hazardous situation, which, if not avoided, will
result in death, serious injury.
Warning!
Indicates a hazardous situation, which, if not avoided, can result in
death, serious injury.
Caution!
Indicates a potentially hazardous situation, which, if not avoided, can
result in injury.
Notice!
Indicates practices which, if not avoided, can result in equipment dam-
!
age.
Danger!
Indicates the exposure to a hot surface.
Caution!
Indicates crushing risk to fingers / hands.
/// General Symbols
Position number
A–––
Indicates device components relevant to actions.
Correct / result
Indicates the correct execution or the result of an action step.
Wrong
Indicates the incorrect execution of an action step.
Note
Indicates steps of actions that require particular attention.
Closed lock!
Indicates the status of "locked".
Open lock!
Indicates the status of "Unlocked".
6
Safety instructions
/// General information
› Read the operating instructions completely before starting up and follow the
safety instructions.
› Keep the operating instructions in a place where it can be accessed by everyone. For the
HABITAT operating instructions it is also available as PDF or to be downloaded from the UI.
› Ensure that only trained staff work with the device.
› Follow the safety instructions, guidelines, occupational health and safety and accident
prevention regulations.
› The device must only be used in a technically perfect condition.
Notice!
!
› Pay attention to the marked sites in Fig. 1.
/// Device design
Caution!
› The power switch of the device must be accessed immediately, directly and without risk at
any time. If access to the power switch cannot be ensured, an additional emergency stop
switch that can be easily accessed must be installed in the work area.
› Ensure that your hands / fingers do not get crushed when setting down the device.
Caution!
› Device surface is partially made of glass:
- Glass surface can be damaged by impact.
- If glass surface is damaged it could cause injury, don`t use the device anymore.
Notice!
!
› Set up the device in a spacious area on an even, stable, clean, non-slip, dry and fireproof
surface.
› The feet of the device must be clean and undamaged.
› Ensure that the power cord set / temperature sensor cable does not touch the heating plate.
› Ensure that the vessel stands safely on the device.
/// Working with the device
Danger!
› Do not use the device in explosive atmospheres, it is not EX-protected.
› With substances capable of forming an explosive mixture, appropriate safety measures must
be applied, e.g. working under a fume hood.
› To avoid body injury and property damage, observe the relevant safety and accident
prevention measures when processing hazardous materials.
› Before use, the vessel system has to be cleaned and sterilized.
› The device is not suitable for hand-held operation.
› Do not touch the rotating parts during operation!
› Autoclaving: 121°C / time, 15-20 minutes
Do not close the hose jacket connectors for the temperature chamber of the double wall
glass vessel while autoclaving! The vessel might get broken! Be aware of the hot surface after
autoclaving!
› Turn off the peristaltic pumps before replacing any tubes or pump heads.
!
7
Advertisement
Table of Contents
